ROTTLER cutting insert 6.35 mm - radius 0.4 mm

RT211 (General purpose and sleeving)

A 1/4” (6.35 mm) IC triangular insert with a black ceramic coating and 1/64” (.4 mm) cutting radius. The 1/64” (.4 mm) radius should be used when machining to a step where the mating part requires a smaller radius to eliminate an interference problem. If you are machining a long bore where the spindle must be extended towards the limits of its travel or if a long stub bar is being used, the 1/64” (.4 mm) radius will minimize the possibility of chatter. A feed rate of .002” - .005” (.05 mm - .12 mm) should be used to

obtain a typical surface finish. When machining large counter bores typically found in heavy duty diesel blocks, a feed rate of .002” - .004”/rev. (.05 mm - .1 mm/rev) should be used. When cutting gray cast iron use a speed in the 800 – 1200 SFPM area for best productivity and tool life.

When cutting nodular, ductile, or compacted graphite cast iron the speed should be in the 200 – 400 SFPM area – 300 RPM on a 4” (100 mm) diameter bore. Nodular, ductile, or compacted graphite cast irons, is found most often in high performance and diesel engine blocks or sleeves.

When cutting these tough cast irons it is best to use a feed rate of between .002 and .005 (.05 mm and .13 mm) per revolution.